

REDS Racing Quattro Clutch System
Elliott Boots explains REDS Racing Quattro Clutch System #TechNitro


Elliott Boots presents REDS #WorldsEdition
Elliott Boots presents and explains the ins and outs of the new Worlds Edition package. http://www.reds-racing.com/worlds-edition #TechNitro


How to change your Reds Engine Bearings
Mike Cradock shows us how to change your Reds Engine Front and Rear Bearings. And also shows you how to fit an adjustable Throttle Return Band to safeguard your engine in the case of loss of power to your servos. #TechNitro


How to look after your Reds Engine, Check and Maintain.
Mike Cradock shows us how to look after our Reds Engines. How to check and maintain them to the same level as the pro racers do. #TechNitro


Mike Cradock explains how to fit your engine, mesh your gears correctly...
Mike Cradock explains how to fit your engine, mesh your gears correctly and set your throttle linkage & end point adjustments in the Kyosho Inferno MP9 TKi3. #TechNitro


Fitting Kyosho Inferno MP9 TKi3 Air Filter
Mike Cradock - Shows you how to fit your Kyosho Inferno MP9 TKi3 Air Filter.
In the next video Mike Cradock will explain how to fit the Reds Exhaust and Kyosho Inferno MP9 TKi3 Fuel Tank. #TechNitro


Engine break-in & tune with Cradock
Breaking in an engine is an essential step since it will determine the overall performance and its longevity. If you are looking for a way to break-in an engine that has proven, nothing like advice from a pro like Mike Cradock. Mike also explains how to tune your engine after break-in. #TechNitro


Reds Engine Setup for Kyosho Inferno MP9 TKi3
Elliott Boots’s mechanic guru Mike Cradock explains how to setup a Reds Engine for use in a Kyosho Inferno MP9 TKi3 in vidéo. Another video coming soon will show you how to mount the engine into the Kyosho Inferno MP9 TKi3 and how to prepare and fit your Kyosho Air Filter properly. #TechNitro
REDS RACING BEARING TOOL KIT INTRODUCTION BY ELLIOTT BOOTS
REDS Engine Bearing Tool Kit set includes puller and presser for pulling out and pressing in front & rear engine bearings. The tool was developed for nitro racers that want to perform critical maintenance on their nitro engines. #TechNitro


ENGINE TEMPERATURE - OFF ROAD
The temperature of the engine is important to save running too lean and causing premature wear or damage. The temperature at which the engine should be run depends upon the ambient temperature, humidity, altitude and the track conditions. Before hitting the track, you must make sure the engine has reached an operating temperature, as putting a cold engine under load can result in wear and damage. Test the engine temperature at the end of each run and if needed make tuning ad